Author Topic: Modding a security DVR's firmware  (Read 5081 times)

Offline motocrossmann

  • New
  • *
  • Posts: 1
Modding a security DVR's firmware
« on: April 26, 2014, 04:43:32 PM »
Using FMK and binwalk, I was able to chop the header and footer off of my Swann DVR's firmware and then mod the Cramfs to update the root password.   When I reassemble it with FMK, and then run binwalk on it, it looks identical to the original with all sections ending/beginning in the sample places.   The contents of the Cramfs do make it a smidge larger, but it still fits into the original "boundaries".   When I go to flash the firmware though, it fails after thinking about it for some time.   I am guessing that there is a checksum somewhere, or some other security feature.   I have no idea how to proceed from here though.   Ideas???



Offline Coldblackice

  • Member
  • ***
  • Posts: 67
  • Gender: Female
Re: Modding a security DVR's firmware
« Reply #1 on: July 13, 2014, 07:15:33 AM »
Any progress (or luck!) with this?

I would also guess it's a checksum issue.

Offline Jeremy Collake

  • Administrator
  • Member#
  • *****
  • Posts: 5222
  • Gender: Male
  • The Lasso
    • Bitsum
Re: Modding a security DVR's firmware
« Reply #2 on: July 27, 2014, 04:35:41 PM »
It does sound like it's probably a checksum / integrity check failure.

Resolution would require further evaluation.

Your best bet is to submit it as an issue at the Google Code site for the FMK.
Software Engineer. Bitsum LLC.